Forum | Interstate Nitro: Aynone need a 4 stroke fit for 3ds? - Forum | Interstate Nitro

Jump to content

Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

Aynone need a 4 stroke fit for 3ds?

#1 User is offline   SilentSniperx13D 

  • Luggage
  • Pip
  • Group: Members
  • Posts: 21
  • Joined: 27-November 08
  • Gender:Male
  • Location:Erie, PA. USA
  • Favorite Gamemode:Don't know

Posted 23 June 2010 - 01:24 AM

I partially made a 3d model of a 4 stroke engine i was going to rig and sell on turbosquid but its too much work. the only thing its missing is the carburator needs setup and it needs valves going to the pistons (should go above the crank case)

Posted Image

If you want the model then ask me.
0

#2 User is online   Cassio 

  • Lead Developer
  • PipPipPipPipPipPip
  • Group: Admin
  • Posts: 1,148
  • Joined: 15-August 06
  • Gender:Male
  • Location:Germany
  • Favorite Gamemode:Scenario

Posted 23 June 2010 - 05:21 PM

No and this stuff is better done in Autodesk Inventor ;)
Posted Image
0

#3 User is offline   SilentSniperx13D 

  • Luggage
  • Pip
  • Group: Members
  • Posts: 21
  • Joined: 27-November 08
  • Gender:Male
  • Location:Erie, PA. USA
  • Favorite Gamemode:Don't know

Posted 25 June 2010 - 07:12 PM

View PostCassio, on Jun 23 2010, 12:21 PM, said:

No and this stuff is better done in Autodesk Inventor ;)


Yeah I know but I did this so I could understand the engine its modelled off more. I'm currently pulling apart a 1982 Honda Xl100 dirtbike for some money (i have to re-ajust the valves so they dont "tick" anymore) but I figured its just easier to pull the engine apart half way through modelling it. lol
0

Share this topic:


Page 1 of 1
  • You cannot start a new topic
  • You cannot reply to this topic

1 User(s) are reading this topic
0 members, 1 guests, 0 anonymous users